What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 23.06.2025 13:28
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
In schematic diagrams this is the symbol for a fuse:
What are some things that children used to wait for, but are no longer common in today's society?
He then asserts :
For this case there are devices called Metal oxide varistors (MOV).
Here is a simplified AC power diagram.
Why do some men like older women?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The other is “what does a “fuse” do?”
Vikingo closes historic Worlds Collide with impressive win over Chad Gable - Cageside Seats
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
Evidence piles up that Trump's tariffs are crushing job market - Daily Kos
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but this device (an Inductor) … impedes the rapid changes in the current.
the problem then depends on "how fast does the fuse operate?".
RBC Canadian Open 2025 prize money: Full payout from $9.8 million purse - Yahoo Sports
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
These are simplified answers to the original question, and does not change anything I wrote above.
The third is lightning and “how it gets conducted into a home.”
Israel is accused of the gravest war crimes in Gaza - BBC
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
(Dc diagram shown, AC is similar).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Ukraine attacks Russian aircraft in far-reaching drone strikes - The Washington Post
It also is a device that limits the change in current flow.
But it can get overloaded, and no longer works.
2024–10–10[John johnson John Johnson ]
Upvotes:
So, the voltage could go up to 500 volts, and the fuse will not open up.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Who is/was the genuinely toughest actor in Hollywood movies?
eight
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One
Talent show: Mocking out the first round of the NBA Draft - Chicago Sun-Times
It seems Mohan does not understand the difference between a comment and an Answer.
A fuse is a non-resetable over current circuit protector.
He then describes the function of a fuse.
How to reduce the age of the heart by 20 years - Times of India
An AC voltage/ current source, and an ac inductive load.
so, what happens?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At least they know the answer if they wanted it.
2024–10–16 [ OO OLAOYE OYEBODE ]
What is lightning?
what exactly is a ‘surge’ protector?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Can you describe what it's like to live in a town known for Harley Davidson motorcycles?
A circuit breaker is similar, but is resettable.
These devices are installed between the “hot” and “neutral” and protective ground.
nine
Edit 2024–10.
He then describes Rainy Season and Lightning.
First Sentence:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are two important concepts here.
[old diagram got deleted by accident]
At one ohm, the resistor has a maximum of 1 watt power.
This device then solves the entire problem.
What does a fuse do?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The MOV will conduct when the voltage exceeds 50% of line voltage.
I post the exact comment here.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is where the MOV conducts again, and dissipated the energy.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The bolt then partially travels down the line to your home.
This one hit behind the barn.
This is where this question deviates from being a 'generic' question, and becomes more specific.
but I think this circuit , shows a few more pieces.
a photo is worth a thousand words.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Because the load is inductive, the current lags the voltage.(by a bit).
There are three different concepts here that are getting confused.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
One is “what exactly is in a ‘surge protector’ ? ”
This is 'the assistant's answer'
[image of Common-mode choke]
Now when you have a certain ac resistance, then a current flows in a loop.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.